Difference between revisions of "Money Money"
From
(→PLD's) |
(→PLD's) |
||
Line 5: | Line 5: | ||
== PLD's == | == PLD's == | ||
=== Lower PCB === | |||
{{PLD_ALL}} | {{PLD_ALL}} | ||
|- | |- | ||
|Bruteforced | |Bruteforced | ||
|[[GAL16V8]] | |[[GAL16V8]] | ||
|6J | |6J | ||
| | | | ||
|Tested | |Tested | ||
Line 19: | Line 20: | ||
|Bruteforced | |Bruteforced | ||
|[[GAL16V8]] | |[[GAL16V8]] | ||
|6K | |6K | ||
| | | | ||
|Tested | |Tested | ||
Line 26: | Line 27: | ||
|[https://wiki.pldarchive.co.uk/pals/MoneyMoney_IC6K.jed JEDEC] | |[https://wiki.pldarchive.co.uk/pals/MoneyMoney_IC6K.jed JEDEC] | ||
| | | | ||
|} | |||
=== Upper PCB === | |||
{{PLD_ALL}} | |||
|- | |- | ||
|Modified | |Modified | ||
|[[GAL22V10]] | |[[GAL22V10]] | ||
|A1 | |A1 | ||
| | | | ||
|Tested | |Tested | ||
Line 40: | Line 45: | ||
For A1, tie pin 10 to 12 when install chip in socket. Original device was a PAL16L8 but unable to fit equations into device | For A1, tie pin 10 to 12 when install chip in socket. Original device was a PAL16L8 but unable to fit equations into device | ||
</pre> | </pre> | ||
[[Category:Arcade]] | |||
[[Category:Zaccaria]] |
Revision as of 15:41, 20 December 2022
PCB
PLD's
Lower PCB
PLD Information | Credits | Download | View | |||||
---|---|---|---|---|---|---|---|---|
Dump Method | Target Device | Location | ID | Status | Creator(s) | Tester(s) | Files | Pictures |
Bruteforced | GAL16V8 | 6J | Tested | Caius | Caius | JEDEC | ||
Bruteforced | GAL16V8 | 6K | Tested | Caius | Caius | JEDEC |
Upper PCB
PLD Information | Credits | Download | View | |||||
---|---|---|---|---|---|---|---|---|
Dump Method | Target Device | Location | ID | Status | Creator(s) | Tester(s) | Files | Pictures |
Modified | GAL22V10 | A1 | Tested | Caius | Caius | JEDEC |
For A1, tie pin 10 to 12 when install chip in socket. Original device was a PAL16L8 but unable to fit equations into device